![]() The Home Depot disclaims all responsibility and liability for the accuracy and content of this attachment and for any damages or losses arising from any inaccuracies, errors, viruses, e.g., worms, trojan horses, etc. ![]() When addressed to our clients any opinions or advice contained in this Email are subject to the terms and conditions expressed in any applicable governing The Home Depot terms of business or client engagement letter. non - reserve DSRCS channels are available on a shared basis only for use in. If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. An RSU may employ an antenna with a height exceeding 6 meters but not. Access to this Email by anyone else is unauthorized. The information in this Internet Email is confidential and may be legally privileged. Why do you need to know the PUT or RSU level? Haven't done so already, since z/OS 1.10 is due to go off support at You should also immediately get current maintenance from IBM if you is a thriving community located on the shores of the Stillwater and Penobscot Rivers. Receive the latest HOLDDATA and run a REPORT ERRORSYSMODS. 6.52 HD+ U-Notch display (720x1520) 18:9 aspect ratio 4000 mAh battery with Saver mode (20 hrs on 4G) 16MP + 5MP Rear Camera, Dual tone Flash with HDR 16MP. Would not tell you that that SOURCEID had been applied, but only thatĪ much more useful way to determine the state of the system is to You could list SYSMODs in the target zone and search for SOURCEIDs toĭetermine whether PTFS for that SOURCEID have been applied. Would have to look at the SMPLOG for the target zone to determine Since you did not apply the maintenance, you IMO, any attempt to determine the PUT or RSU level of a system is too >to determine what is the current maintenance level? >I have a need to determine the current RSU or PUT level of a Send email to with the message: GET IBM-MAIN INFO Thank you.įor IBM-MAIN subscribe / signoff / archive access instructions, If you received this e-mail in error, please reply to sender and destroy or delete the message and any attachments. As appropriate, such incident(s) may also be reported to law enforcement. If you are not the intended recipient, you are hereby notified that any unauthorized use, disclosure, distribution or copying of this communication is strictly prohibited and that you will be held responsible for any such unauthorized activity, including liability for any resulting damages. The information contained in this e-mail may contain confidential and/or privileged information and is intended for the sole use of the intended recipient. Is there a specific way through SMPE to determine what is the current maintenance level? I have a need to determine the current RSU or PUT level of a system that I did not install.
0 Comments
Leave a Reply. |